Aleratec Roboshredder Manuel d'utilisateur télécharger pdf (Page 7)

www.aleratec.com

Problems and Solutions

When a minor jam occurs, your RoboShredder will automatically reverse and

then resume shredding. This will clear most jams. In case of a stall, follow the

directions below.

Basic Paper Jam

The shredder should automatically eject any minor excess material from the

feed openings. Manually remove any unshredded material from the top of the

feed openings. If the jam occurs in the auto-feed slot, gently raise the feed

cover and remove excess material from the opening.

Minor Paper Jam

Press the REVERSE button on the control panel. The shredder will reverse

momentarily, then resume shredding. If shredding does not resume, remove

unshredded portion of paper from the entry slot or auto-feed slot (by lifting the

feed cover) and clear any excess paper shreds.

Major Paper Jam (Overload lit on LED panel)

1. Turn the power switch to the OFFposition(○)andwaitatleast10

minutes for the thermal overload protection to reset.

2. Turn the power switch ON ( – ). If paper was left inside any feed opening

prior to the overload, press the REVERSE button. Be careful to not place

yourngersnearthefeedopeningorseriousharmcouldresult.Clearany

excess paper shreds from the feed opening. You are now ready to resume

normal shredding.

Paper Jams and Motor Overload Situations

The shredder is equipped with an automatic motor overload protection

circuit. The duty cycle for the shredder is rated for continuous shredding.

Recommended running time at maximum capacity is 30 minutes on and 40

minutes off when using the auto feed tray, 40 minutes off when feeding the

shredder normally. The shredder will automatically terminate power if any of

the following abnormal situations occur:

1. Operating the shredder at the maximum 10-sheet capacity continuously for

a prolonged period of time, e.g., more than 30 minutes without stopping.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Pas de commentaire

Aleratec Roboshredder Manuel d'utilisateur Page 7